Zoning Maintenance Question

Hi everyone. First off, thanks in advance for the much needed help! Last week, I noticed my zoning system was putting out air on both floors of...

Repairing the shower 90 degree elbow

Hey all, While removing the shower head arm for a replacement shower, even with taking care to not bend it at odd angles, it still broke off. I found the file method described here (http://www.doityourself.com/forum/plumbing-piping/196891-removing-broken-shower-head-extension-pipe-elbow.html), but unfortunately it did not work for me (partially due to my stupidity), and I wound up with the pipe still quite firmly stuck in there. Several rounds of cutting and excavating later using 'techniques' that are not too far off from laparoscopic, and I'm at the point where it looks like I may have to be replacing it. I thought I'd check in to see if anyone happens to have some advice on the matter, or if I have to resign myself to removing the tile, the board behind it, desolder the thing, solder on a new one, reconstruct the wall, etc. Having never done that sort of thing is a bit daunting. Thanks!

interesting issue..... need gas furnace troubleshooting help

Greetings all! Woke up this morning to find out that my heating system is not turning on. Sentry s-90 dp gas hot water system, 1 zone. I spent the last few hours reading and researching, putting pieces together but there is still something missing. The problem: When the thermostat calls for heat, the relay clicks but the damper does not move, therefore heat does not go ON. But....

Selecting a contractor and equipment

I have already received a number of quotes, but have not made any decisions on a contractor and equipment. I am replacing a 19 year old rheem 4 ton...

Z1100 that the ready to arm light will not turn .

Hello, I have a z1100 that will not arm. The light will blink or stays off when I try to arm the system. I have been struggling with this system for a while so I am at the point I have all window and door switches taken off the zones and have all 8 zones jumped with wires. I still can not get the ready to arm command. I check the zone status command and it shows all 8 zones open. Could this be a main board problem. Any suggestions would be appreciated. Thank you, Jay

Question regarding condensate pan/pump on furnance

Hello, I recently noticed the condensate pump was running 100% of the time on my Trane XL90 furnance and that the condensate drip pan was full...

Pretty desperate situation - advice please

Long story... Had a Carrier Infinity 96 installed four years ago, being told by our furnace installation company it was the best and most...